SoftHub

Upgrade Process:

- Save the upgrade files obtained from your installer or distributor in a compatible USB flash drive

- Insert it into the USB port at the front panel.

- Then, click “SUBMIT” to start upgrading.

Note: 

- Before using the USB flash drive, please use your PC to format the USB flash drive to FAT32 format first.

- After upgrading firmware, it’s recommended to clear all hard disk data for the system to work more stably. Before clearing all hard disk data, please remember to make video backup.

- Before remote firmware update, please install a hard disk into your recorder first to make sure the firmware update works properly.

Network Upgrade:

- Click “SUBMIT” for perform system upgrade via Internet.

Note: This function requires Internet access. Please make sure your recorder is connected to Internet before using this function.

Backup Config / Restore Config 

- To keep the current configurations after upgrade, insert a compatible USB flash drive into the USB port, and select “SUBMIT” in “BACKUP CONFIG” to copy the current configurations to a file “System.bin” and save to your USB flash drive. To restore the configurations, insert the USB flash drive including “System.bin” to the USB port, and select “SUBMIT” in “RESTORE CONFIG”.

Enable Auto Plug and Play

- Switch to “ON” allow the camera to be detected and configured automatically when it’s connected to this device. Note: This function is available only when the brand of the cameras connected is the same as this device

About NVR Firmware:

Applying a new firmware package on your Network Video Recorder (NVR) should improve overall performance and stability, fix various issues encountered with the device, or add support for newly developed features.

The NVR should be carefully upgraded by a power user (that is to say, someone who has the know-how to successfully complete the process), but it can also be performed by an average user at his or her own risk.

Either way, given the fact that each producer has their own method for installing a new firmware, and that every device has a particular way to enter the update mode, you must not consider upgrading the software until you have read and thoroughly understood the installation steps.

As a rule, said steps shouldn’t pose too much of a challenge because manufacturers strive to make them as easy as possible. As with everything else, exceptions do occur, and users should be prepared for them.

Usually, you should transfer the compatible firmware to the Recorder through a USB cable or a memory card, and afterwards enter update mode from the unit’s setup menu or through a specific power-on method.

With this in mind, if you intend to apply this release, make sure the package is compatible with your Network Video Recorder and that it brings about the changes you want or require; hit the download button and apply the new firmware.

Don’t forget to regularly check with our website so that you don’t miss any updates.

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

AVTECH AVH0801 Firmware AVH0801 Network Recorder Firmware AVTECH AVH0801 Firmware Update AVH0801