SoftHub

New Features

- Added support for Wow64

- Added support for Windows 8 32-bit

- External Trigger source can know be set to 'Software Trigger' in order for the board to ignore any physical trigger applied to the board.

- Added support for Acq Status CORACQ_VAL_SIGNAL_PIXEL_CLK_1_PRESENT, CORACQ_VAL_SIGNAL_PIXEL_CLK_2_PRESENT, CORACQ_VAL_SIGNAL_PIXEL_CLK_3_PRESENT, CORACQ_VAL_SIGNAL_PIXEL_CLK_ALL_PRESENT

Fixes:

- Installation Error if installing with Sapera 5.xx.

- Fixed BSOD that would occur with Sapera 7.0 and below when using 64-bit demos/applications that uses Scatter-Gather buffers instead of Scatter-Gather/Physical buffers.

- When using a dual camera configuration, possibility of events being turned off when creating an Xfer handle on one camera while grabbing with the other one.

- Driver will now detect disconnect/connect of 2nd Camera Link cable when applicable. The Pixel Clock Present/Absent event/status will reflect the combination of all required pixel clocks based on the Camera Link Configuration selected.

- 3-Tap parallel with Medium configuration is now available. Feature was lost since driver 1.50.

- Fixed support for time stamp in msec. It would return values in usec.

- Buffer host PC time stamp would be ' 0' except for 1st frame of a sequence when EXT_TRIGGER_FRAME_COUNT > 1.

- Random buffer host PC time stamp = 0 when grabbing from dual channel camera.

- Improved prevention of BSOD upon reset of the board that can occur in some computers. Solution needs SaperaLT 7.40 and up.

- Windows 8 hybrid shutdown in combination with adding/removing board(s) in between reboots can cause boards not to be mapped properly on some PCs. If this is the case, a restart of the PC will be requested by TDALSA Device Manager.

- Under Windows 8, driver will not create tiles anymore and will create a proper Application group containing the driver's tools and documentation.

- Strobe Output would be pulled low before being set to tri-state when disabling the output causing possible glitch if strobe is set to active low.

About Device Driver:

If you install this package, your device will be properly recognized by compatible systems, and might even benefit from new features or various bug fixes.

Please note that, even though other operating systems might also be compatible, we do not recommend you apply any software on platforms other than the specified ones. Doing so might cause the installation to crash, which could even render the device unusable.

When it comes to installing the package, the steps should not be much of a hassle because each manufacturer tries to make them as easy as possible; usually, you must make check for compatibility, get the package, run the available setup, and follow the instructions displayed on-screen.

However, due to the large number of devices out there and the various ways for applying these packages, it would be best if you refer to the installation manual first, to be sure of a successful update.

That being said, click the download button, and apply the present software on your product. Also constantly check with our website to stay up to speed with latest releases. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

X64-CL iPro Driver for Sapera LT Imaging Library X64-CL iPro Device Driver Teledyne DALSA X64-CL iPro Driver