SoftHub

Fixes:

- Original Prusa i3 MK2 support

- Printer selftest function added

- Print statistics function added

- Improved stop print menu

- Autocalibration (MK2 only)

- Thermal runaway reimplementation

Determines what type of п¬Ѓlament is your printer using

There are two options:

- 1_75mm_MK2 represents 1.75mm п¬Ѓlament (latest and in use on MK2)

- 1_75mm represents 1.75mm п¬Ѓlament ("MK1" only)

- 3mm represents 3mm п¬Ѓlament (no longer used)

About Firmware Package:

Before you even consider installing this firmware, go to the system information page of the device and make sure that the version currently installed on it isn’t newer or matching this one.

If you upgrade to this build, imaging devices can get printing and scanning quality improvements, new options added to the setup menu, feature enhancements, various fixes, as well as several other changes that can boost stability.

Considering the large number of devices and manufacturers, as well as the wide variety of methods for upgrading imaging units, we recommend that you read the installation steps and initiate a firmware update process only when you have familiarized yourself with the procedure.

In addition to that, it would be best if you perform this task in a steady power environment such as the one ensured by a UPS unit. Also, make sure you don’t power off the imaging device or use its buttons during the installation, in order to avoid any malfunctions.

Therefore, if you intend to apply this version, click the download button, and install the package. Remember to check with our website as often as possible so that you don’t miss a single new release. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Prusa 3D Printer Firmware Prusa3D Firmware Update Prusa Firmware Update Prusa3D Printer Firmware Prusa