SoftHub

Improvements

- The default audio levels of the [Transceiver Model] items in the [Port Settings] menu have been optimized.

- The firmware update fixes the problem where communication may fail when the VE-PG3 is in the Bridge mode and it is connected to an IDAS Multi-site trunking system.

NOTE:

- If you update to firmware version 2.14, you cannot downgrade to version 2.04 or earlier versions.

- Setting files made by firmware version 2.14 cannot be used by version 2.04 or earlier.

- Make a backup of your current data before downloading and installing the firmware update.

- The procedures to optimize the audio levels with the new 2.14 firmware depend on the transceiver models connected to the TRX and EXT (if used) ports of the VE-PG3.

- Access the VE-PG3 setting screen in your web browser and select the [Port Settings] menu. Then click on the [Transceiver 1 (TRX1)], [Transceiver 2 (TRX2)], [EXT I/O 1 (EXT1)] and [EXT I/O 2 (EXT2)] (if EXT I/O ports are used) menus.

- In the [Transceiver Model] item, if IC-F5060/F6060 is selected in both TRX ports, the default audio levels will automatically be optimized after the firmware is updated. No further action is necessary.

- If the [Transceiver Model] item in either of the TRX ports is a model other than IC-F5060/F6060 or if either of the EXT ports is used, you must manually optimize the default audio levels by doing the steps below:

Initially select a model in [Transceiver Model] that is different than the model you are using, and then click <Apply>.

Finally select the model in the [Transceiver Model] that is the actual model you are using, and then again click <Apply>.

Do the steps for all TRX and EXT (if used) ports, even if one had the IC-F5060/F6060 selected.

About Gateway Firmware:

By applying this firmware, your gateway can receives fixes for various vulnerability issues, support for newly developed technologies, several authentication-related enhancements, as well as other changes.

However, due to the wide variety of gateway models, as well as the large number of manufacturers, in order to perform a firmware update properly, it would be best if you read and understand the installation steps of this specific model.

In addition to that, it is also recommend that this process be initiated in a steady power environment, and only when you have completely familiarized yourself with the upgrade procedure.

Bear in mind that failing to perform a successful update or interrupting the firmware installation in any way can cause serious malfunctions to the gateway, and might even render it unusable.

Therefore, if you intend to install this version, click the download button and apply it to the gateway. To stay up to date with new releases, all you have to do is check back with our website as often as possible. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Icom VE-PG3 Firmware VE-PG3 Gateway Firmware VE-PG3 RoIP Gateway Firmware VE-PG3 Firmware Icom Gateway