SoftHub

Update Instructions (f YI Smart Dash Camera cannot boot normally, try push the reset button on the top of the camera with a pin. If the camera still cannot boot):

- Download FWCARC10.bin to the micro SD card and put it in the root directory (make sure the file name remains FWCARC10.bin)

- Insert the micro SD card in the camera

- Connect the camera to a power source, then switch on the camera

- The yellow light at the right-bottom corner of the camera will flash, but the screen remains dark (if the light is not flashing, push the reset button on the top of the camera with a pin)

- Wait for 1-5 minutes before the update is successful and the camera is restarted

- Format the micro SD card after the camera is successfully restarted, otherwise the update process will be started every time the camera is restarted

Notice:

NEVER cut off the power source or shut down the camera while update is in progress.

Device Requirement:

- One Class10 80 MB/s reading speed micro SD card, 8-32 GB

- One Windows PC

- USB power source, can be USB charging port or portable USB battery kit, 1A Output

About Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Yi Smart Dash Camera Firmware XiaoYi Smart Dash Camera Firmware XiaoYi Yi Dash Camera Firmware Yi Smart Dash Camera Firmware