SoftHub

This package provides the installation files for Stealth Cam STC-RX24 Camera Firmware version 01.00.39.

Software Update:

Note: It is recommended to perform the software update using new batteries. Loss of battery power during the software update may cause the camera to be non-operational.

1. Place the Software Update Files onto the root of an SD Card.

2. Place the SD Card into the SD Card slot of the camera.

3. Slide the 6-position switch into the Custom position.

4. Press MENU to enter the menu selection.

5. Press the UP button to select the SW UPGRADE menu item.

6. Press the ENTER button then the UP button to change the selection to YES.

7. Press the ENTER button to start the upgrade process.

8. The upgrade process takes approximately 1 minute and 40 seconds to complete. The screen will display software upgrade status texts during the process.

Warning: Do not turn camera off or eject battery tray during the software upgrade process. Loss of power to the camera may cause damage.

9. After the upgrade process is complete, the LCD screen backlight will stay on and the screen text will be removed/very faded from the screen if you look at it straight on.

10. Turn the camera to the Off position.

11. Press the EJECT button to eject the battery pack from the camera. Wait 5 seconds before re-inserting the battery pack.

12. Re-insert the battery pack and slide the switch into the Test position.

13. The software version shown on the screen should now be V01.00.39 130023.

IMPORTANT: Make sure you put a freshly formatted SD card into your camera.

About Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance.

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Stealth Cam STC-RX24 Firmware STC-RX24 Camera Firmware