SoftHub

AUTODOME IP 5000 HD

- Choice of 720p25/30 or 1080p25/30 HD resolution, 30x optical zoom with Bosch’s imaging platform specially designed and tuned for accurate color reproduction in scenes with varying lighting levels from day to night

- Identification of people up to 190 m(623 ft) without loss of any details

- High-speed PTZ control for tracking people and vehicles in large indoor/outdoor scene

- Exceptional low bit rates in static scenes to save the storage cost by up to 50% compared to any equivalent dome in the market

- ONVIF Profile S and third party software support for easy integration with VMS

Changes:

- An issue with increased noise and thereof increased bit rate from AUTODOME and MIC cameras has been fixed.

- Auto Focus accurateness on DINION IP bullet 4000 and DINION IP bullet 5000 has been improved.

- An issue with fragmented EAP-TLS transfer has been fixed, allowing support for Microsoft Windows NPS and RADIUS.

- An issue with ONVIF Analytics Service has been fixed.

- GUI translations and some embedded help files have been updated.

- An issue with analogue output flickering on DINION IP starlight 7000 and FLEXIDOME IP starlight 7000 in 1.3 MP mode has been fixed.

- Wrong wording on time protocol settings has been fixed.

Note:

Due to an internal file system being introduced since firmware 6.1x and architectural changes thereof, an upgrade to firmware 6.20 and higher is only possible from firmware 6.1x versions or higher. Cameras with previous firmware versions below 6.1x first need to upgrade to firmware 6.1x.

Note:

Since firmware 5.92 no Autoload Decoder can be installed from the camera anymore. This video decoder, used in browsers to view the video stream, had to be taken out of the firmware content due to size limitations, favouring the new features. Instead, a download link to get the more feature-rich MPEG-ActiveX has been inserted, requiring Internet access for immediate installation.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Autodome IP 5000 HD Camera Firmware