SoftHub

AUTODOME IP 7000

- Day/night IP camera with 28x or 36x optical zoom (12x digital zoom), Wide Dynamic Range (WDR), and Sodium Vapor White Balance mode that restores objects to their original color

- New Intelligent Tracking and alarm rules engine with on-board Intelligent Video Analytics (IVA)

- Enhanced system flexibility with dual recording options (iSCSI, SD card)

- Fully configurable quad streaming with individually configurable SD streams, based on Bosch’s new Common Product Platform (CPP4)

- Easy and intuitive installation with multiple pre-configured user modes that allow users to select the camera configuration that is ideal for their applications

New Features

Support of new camera modules in AUTODOME 7000 and MIC 7000, providing improved noise reduction.

- A high-resolution/limited-frame-rate capability has been introduced for stream 2 on various cameras.

Changes

- Writing to ONVIF MaxFrameRate is now possible to improve compatibility with clients not using encoding interval. Written values are presented in same format when read.

Note:

Due to an internal file system being introduced since firmware 6.1x and architectural changes thereof, an upgrade to firmware 6.20 and higher is only possible from firmware 6.1x versions or higher. Cameras with previous firmware versions below 6.1x first need to upgrade to firmware 6.1x.

Note:

Since firmware 5.92 no Autoload Decoder can be installed from the camera anymore. This video decoder, used in browsers to view the video stream, had to be taken out of the firmware content due to size limitations, favouring the new features. Instead, a download link to get the more feature-rich MPEG-ActiveX has been inserted, requiring Internet access for immediate installation.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer

Autodome IP 7000 Camera Firmware Bosch Security Autodome IP 7000 Firmware