SoftHub

Known Issues:

- Device will add an extra VLAN 1 for downstream packets in the DSL WAN bridge mode.
- Solution: Use the CLI to edit the LAN port as untagged. router>vlan edit br0 --vid 1 --desc Default --intervlanrouting enable --port1 untagged --port2 untagged --port3 excluded --port4 excluded router>save.

- Sometimes the PC is unable to get an IP after completing the reboot process.
- Solution: Reboot the device or setup a static IP address on the PC. Then, go to the GUI>LAN>LAN Configuration page to disable, then enable the DHCP server.

- The VLAN can’t be set when a WAN sub-interface is created by TR069.
- Solution: Use the web UI or CLI to configure the VLAN ID for sub-interface.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.