SoftHub

Resolved Issues:

- Fixed an issue where a time zone was not displayed for India, and incorrect time zones were displayed for Kabul, Mumbai, New Delhi, Kathmandu, and Darwin. (CSCug39617)
- Fixed an issue where the Password Expiration feature did not work. (CSCuf93284)
- Fixed an issue where DOS FTP traffic initiated over PPTP locked the router. (CSCug25381)
- Fixed an issue with a buffer overflow in libupnp, the portable SDK for UPnP Devices. (CSCue20980)
- Fixed an issue where when users entered special characters in the fields on the DHCP Setup page, the DHCP Status field would display a blank content frame. (CSCud96742)
- Fixed an issue where the device responded to external port probes on port 0 and port 1. (CSCuc32147)
- Fixed an issue where when users connected to the device, incorrect logs were generated. (CSCuc37893)
- Fixed an issue, where IPSEC VPN connectivity was not restored after power loss. (CSCuc66316)
- Fixed an issue where IPv6 Tunnel 6-to-4 is enabled by default. (CSCue04572)
- Fixed an issue to display the correct device description instead of ‘Linux Gateway Device’ and ‘Intel Device SPY’, when Universal Plug and Play (UPnP) is enabled. (CSCtq46587)
- Fixed an issue where when multiple phones on the LAN used the same SIP port, the router changed the SIP ports on every registration and did not maintain existing NATing, which resulted in the foreign end bye getting dropped. (CSCty22521)

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.