Драйвер Cisco 1.0.4.10 Cisco Router Firmware RV120W

Наименование1.0.4.10 Cisco Router Firmware RV120W
Дата добавления26.01.2016
Описание

Changes:

- Adding a 1-to-1 NAT service to a subnet only works when adding the service to a subnet of VLAN1.
- Port forwarding does not work when the port is specified.
- The external syslog server receives only kernel messages from the RV120W.
- Internet NAT redirection does not work when services are forwarded using port forwarding.
- Microsoft Internet Explorer version 8 accessibility upon reboot issue. NOTE: To prevent problems, clear the web browser cache after the router is upgraded.
- PPTP connected/configured users are not shown on the VPN Client Connection Status page.
- Enable inter-VLAN option does not work when setting up multiple VLANs at one time.
- The QuickVPN client cannot access the computers in the LAN of the RV120W when the LAN subnet is smaller than a /24 subnet. NOTE: The lower limit for subnets is /24.
- If a manually-configured NTP server is used, the RV120W does not synchronize with the NTP server after a reboot.
- The IPSec Connection Status takes too long to recognize that the VPN tunnel has been disconnected. NOTE: Dead Peer Detection must be enabled for the IPSec Connection Status to reflect the current tunnel connection status.
- PPTP connection remains active after a PPTP user is disabled or deleted in the RV120W.
- 6to4 Tunneling will not work when SLA ID is set to zero.
- 6to4 tunneling requires a static route to work.
- Windows native FTP File transfer fails when using QuickVPN behind NAT on Windows 7.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

Имя файлаRV120W-Firmware-1.0.4.10.img
Поддерживаемые ОСОС Независимый
Размер14 МБ
Поддерживаемые устройстваНе задан
Количество скачиваний0
Вы можете скачать драйвер Cisco 1.0.4.10 Cisco Router Firmware RV120W с сайта производителя нажав на кнопку "Скачать".