SoftHub

Issues Resolved:

- The device formats the SIP packet and fragments it, causing the invitation to fail.
- When rebooted, the device does not display the DHCP leased clients.
- Traceroute skips the local default gateway and reports the destination IP as the first hop.
- The device configuration file contains subnet 176.x.x.x as the DMZ.
- QuickVPN connection becomes inactive and users cannot connect after five days.
- When a device on the LAN sends data over the Internet, sometimes the source IP address is not translated to the public WAN address.
- Static route entries are truncated up to the last character.
- CPU and Memory values on the device Dashboard are not updated.
- Traffic does not follow the bandwidth limit when the traffic selector is set to VLAN or SSID.
- The RV180 is unable to send logs by e-mail, using port 25.
- The Average per Day counter of the WAN Traffic Meter does not work correctly.
- When users click Make Static IP in the DHCP Leased Clients tab, only clients in VLAN 1 are updated in the Static DHCP table.
- The device does not forward HTTP responses when wireless clients move from an access point's wireless to the router's wireless, if the access point is connected to a LAN port.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.