SoftHub

Changes:

- Fixed an over-subscription on the RX buffer when Flow Control was not enabled which caused the RX pipe to hang.
- Fixed an issue causing the firmware to hang when running ibdiagnet. The received DiagData MAD included the following values: Clear_all = 1, PageNum = 0, Port_select = 0. To prevent the firmware from hanging, a port check was added to Set() as well.
- Fixed an issue causing Port 2's GPIO present to be mapped to the wrong value in ConnectX-4 EN 50GbE single-port adapter card OPN MCX-414A-GCAT

About Network Adapter:

When connected, the operating system usually installs a generic driver that helps the computer to recognize the newly attached device.

However, proper software must be applied if you want to make use of all features that the network adapter has available. This task also allows computers to properly recognize all device characteristics such as manufacturer, chipset, technology, and others.

Updating the adapter’s drivers and utilities version might improve overall performance and stability, increase transfer speeds, fix different compatibility problems and several network-related errors, as well as bring various other changes.

To install this release, simply get the package, extract it if necessary, run the setup, and follow the instructions displayed on-screen. When done, don’t forget to perform a system restart and reconnect the network adapter to make sure that all changes take effect properly.

Without further ado, if you intend to apply this version, click the download button and install the package. Moreover, check with our website as often as possible so that you don’t miss a single new release.