SoftHub

What's new in 6.34rc16:

- dude - “The reports of my death have been greatly exaggerated”;
- dude - dude RouterOS package added for tile and x86 (CHR) architecture;
- dude - initial work on dude integration into RouterOS;
- webfig - didn't show zero values in CRS ingress/egress vlan translation rules;
- netwatch - make work with ping timeouts more precise;
- btest - fix crash on stop/start with fastpath enabled;
- hotspot - added missing favicon.ico in hotspot html pages;
- dhcpv6 - various changes on client, server, relay optimization;
- arp - show incomplete arp entries;
- hotspot - show cookie add/remove events in hotspot,debug log;
- hotspot - allow static entries with the same mac on multiple hotspot servers;
- hotspot - do not remove mac-cookie in case of radius timeout;
- hotspot - added byte limits option for default-trial users;
- ipsec - make sure that dynamic policy always has dynamic flag;
- CAPsMAN - use CAP name in log when remote-cap is deleted (wireless-cm2);
- hotspot - fixed login by mac-cookie when roaming among hotspot servers;
- hotspot - add html-directory-override for read-only directory on usb flash;
- hotspot - add uptime, byte and packet counter variables to logout script;
- net - fix statistics counters jumping up to 4G;
- firewall - SIP helper update for newer Cisco phones;
- usermanager - fixed usermanager webpage crash;
- ipsec - fixed active SAs flushing;
- hotspot - added option to login user manually from cli;
- hotspot - fixed trial-uptime parsing from CLI to Winbox/Webfig;
- lte - added support for multiple E3372 on the same device;
- modem - added wpd-600n ppp support;
- console - fixed incorrect disabled firewall rule matching to "invalid flag";
- dns - fix for situation when dynamic dns servers could disappear;
- sfp - fix 10g ports in 1g mode (introduced in 6.34rc1);
- CCR1072 - added support for S-RJ01 SFP modules;
- trafficgen - fixed issue that traffic-generator could not be started twice without reboot;
- dhcpv6-server - replace delay option with preference option;
- dhcpv6-client - added address acquisition support;
- dhcpv6 - implement and enable rapid commit by default.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.