SoftHub

Bug Fixes:

- Fixed the issue where 10G SFP+ port is unable to link up after switch reload with customer's config

Changes and Restrictions:

- If the network is configured as DHCP mode on the previous version, after it upgrades to 11.0.0.11, the "network" interface protocol mode will change to "none," and its IP will be set to "0.0.0.0" and DHCP mode is enabled on management VLAN instead.
- M7100 will not support IPv6 management if L3 license (routing and multicast) was not installed.
- The auto install is not allowed to apply a config file if the startup-config file contain the commands related to the "network" interface which is not supported on 11.0.0.11.
- If user configures the ports as protected port, routing mode is not allowed to configure on the VLAN in which those protected port are added.
- PVST/PVST+ M7100 only supports VLAN ID range from 1 to 1024. If user enables the PVST, make sure all of VLAN IDs are in the range of 1 to 1024.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend th